What the Change Audio Volume does
Change Audio Volume raises or lowers the level of a recording that is too quiet or too loud. It shows the loudest point and the average level of the file in decibels, lets you change the volume from −30 to +30 dB with a slider or one tap, and has a Normalise button that makes the loudest point exactly −1 dB, as loud as it can go without distortion. A clipping guard stops anything pushed past full scale from crackling.
How to use it
- Drop an audio file onto the page.
- Move the slider, tap a preset such as +6 dB, or press Normalise to −1 dB.
- Check Loudest point after; it turns red if the audio would clip.
- Press Change volume, listen to the result and download it.
Example
The sample MP3 peaks at −4.2 dB with an average of −23.2 dB. Normalise sets the change to +3.2 dB, or 145%, and the saved file peaks at −1.0 dB. Raising it by +10 dB instead would push the peak to +5.8 dB, so the tool warns that the loudest parts will be flattened.
Decibels in plain terms
Every +6 dB roughly doubles the signal level and every −6 dB halves it; +10 dB sounds about twice as loud to most people. 0 dB is full scale, the most a digital file can hold, so peaks should stay below it.
Normalising only raises the whole file evenly until its loudest moment reaches the target. It does not compress the sound, so a recording with one very loud bang will still sound quiet afterwards. In that case, trim the bang first.
Questions people ask
Is my audio uploaded?
No. The file is opened and processed in your browser, so it never leaves your device. That also means it works on recordings you would not want to share.
What does prevent clipping do?
Samples pushed above full scale are held at full scale instead of wrapping into harsh noise. Keep it on unless you need the raw values.
Can I make it quieter too?
Yes. Move the slider below zero, for example −6 dB for about half the level.
Why is the average level so much lower than the peak?
Speech and music have short loud moments and long quieter ones. The average (RMS) shows how loud it feels; the peak shows how close it is to distortion.