About this chart
This chart turns every millimetre from 1 to 100 mm into inches, both as a decimal to 3 places and to the nearest sixteenth of an inch, the smallest mark on most imperial tape measures. Use it to match metric drill bits, bolts, screws, pipe and timber to imperial sizes, or to read a metric drawing with an imperial ruler. An inch is exactly 25.4 mm, the value the Unit Converter below the chart uses for any other length.
How to use it
- Find the size in millimetres in the chart.
- Read the inches as a decimal, or the nearest fraction for a tape measure.
- If a part must fit exactly, use the decimal, as the fraction is rounded.
- For lengths over 100 mm, use the CM to Inches Chart or the Unit Converter.
Example
A 10 mm drill bit is 0.394 inches, nearest to 3/8″ on a tape measure. A 6 mm bolt is 0.236 inches, close to 1/4″, and a 19 mm board is 0.748 inches, close to 3/4″.
The formula
Divide millimetres by 25.4 to get inches. To get sixteenths, multiply the inches by 16 and round to a whole number: 10 mm is 0.394 inches, and 0.394 × 16 = 6.3, so about 6/16, which simplifies to 3/8 inch. A sixteenth of an inch is 1.5875 mm, so the fraction can be up to about 0.8 mm away from the true size.
Close is not always the same
Many metric and imperial sizes look interchangeable but are not. A 13 mm spanner is close to 1/2 inch but slightly larger, and an 8 mm bolt will not go through a 5/16 inch hole. For loose fits, such as a drill hole for a wall plug, the nearest size is fine. For threads, bearings and anything that must be tight, use the right system rather than the nearest match.
Questions people ask
How many inches is 1 mm?
About 0.0394 inches, a little under 1/25 of an inch.
What is 25 mm in inches?
0.984 inches, just under 1 inch. 1 inch is exactly 25.4 mm.
What fraction of an inch is 5 mm?
About 3/16″. As a decimal it is 0.197 inches.
How do I print this chart?
Press Print chart above it. Only the chart is printed, in black on white, without the menu, the tool or the rest of the page. Choose A4 or Letter in your print settings.